Modular Type Cable Termination for 25kV
35MT series of termination provide a class 1 termination conforming to the requirements of IEEE Std.48-1990 for 25kV
system and IEC Std.40502-4-1997 through 25kV system. Typical uses for 35MT termination are in switchgear and
pad-mounted transformers.
Single-piece Cable Termination for 25kV
25SMT series of termination provides a class 1 termination conforming to the requirements of IEEE Std.48-1990 for 25kV
system and IEC Std.40502-4-1997 through 12/20(24)kV system. Typical uses for 25SIT are in pole-mounted transformer and
for motor connection.
Power Cable Joint for 15kV to 35kV
PYUNGIL power cable joints(PCJ) conforms to the requirements of IEE Std.404-1993 through 15kV to 35kV to assure system
matched performance and rating equal to the cable to be installed. PCJ is a permanent fully-shielded,fully submersible
cable joint for direct burial or vault application. It can be used to join cable runs on a new installation or to repair broken
cable runs on an existing installation.
EPOXY BUSHING
PYUNGIL bushing has the sensor ring device used for voltage detection inside of the bushing
for the automated remote control system. The bushing meets the full requirements of IEEE Std. 386.
Typical applications would be in :
• Transformer • Pole-mounted Switch-gear
PYUNGILl's apparatus bushings are for in-oil or SF6 gas applications. The bushing is molded of epoxy and installed
with a bracket to the apparatus. In the installation,no special tools are required. Refer to PYUNGIL's installation instruction
Product List
Modular Type Cable Termination for 25kV
35MT series of termination provide a class 1 termination conforming to the requirements of IEEE Std.48-1990 for 25kV
system and IEC Std.40502-4-1997 through 25kV system. Typical uses for 35MT termination are in switchgear and
pad-mounted transformers.
Single-piece Cable Termination for 25kV
25SMT series of termination provides a class 1 termination conforming to the requirements of IEEE Std.48-1990 for 25kV
system and IEC Std.40502-4-1997 through 12/20(24)kV system. Typical uses for 25SIT are in pole-mounted transformer and
for motor connection.
Power Cable Joint for 15kV to 35kV
PYUNGIL power cable joints(PCJ) conforms to the requirements of IEE Std.404-1993 through 15kV to 35kV to assure system
matched performance and rating equal to the cable to be installed. PCJ is a permanent fully-shielded,fully submersible
cable joint for direct burial or vault application. It can be used to join cable runs on a new installation or to repair broken
cable runs on an existing installation.
EPOXY BUSHING
PYUNGIL bushing has the sensor ring device used for voltage detection inside of the bushing
for the automated remote control system. The bushing meets the full requirements of IEEE Std. 386.
Typical applications would be in :
• Transformer • Pole-mounted Switch-gear
PYUNGILl's apparatus bushings are for in-oil or SF6 gas applications. The bushing is molded of epoxy and installed
with a bracket to the apparatus. In the installation,no special tools are required. Refer to PYUNGIL's installation instruction
Product List